Room power that follows check-in and check-out
Large hotels use key-card switches to cut room power when a guest leaves. Smaller hotels, lodges and guest houses usually rely on housekeeping to go room to room. A Mishka output on each room's supply, linked to your check-in system, does the same job automatically.
How it works
- Each room's supply is wired through one Mishka output (the “main” device for that room). AC, lights or the geyser can also have their own outputs (“room devices”).
- The front desk checks the guest in on the room board. The room's supply turns ON at once.
- Thirty minutes before the stay ends, the desk gets a notification and can extend the stay in one tap.
- At check-out — or when the time is over — the supply and every room device turn OFF by themselves.
Why it helps
- No AC or geyser left running in an empty room.
- No room used without a check-in — power follows the stay.
- Housekeeping doesn't need to walk the corridors switching things off.
- Lobby lights and pumps stay on separate outputs, untouched by check-outs.
Night and hourly stays
Night stays end at your check-out time on the last day. Rooms with an hourly rate can also be booked by the hour; those stays end that many hours after check-in. Rent, the advance and the balance are worked out for you.
Without devices
The room board, check-in, rent and reports work without any devices. You can start with the software and add room power control later.
Who can do what
- Admin (owner): rooms, rates, devices, staff, reports.
- Front desk: check-in, extend, check-out — power follows.
- Unrestricted staff: like the owner at the desk, including switching any room.